Listing of rolechg_config
#
# CDDL HEADER START
#
#The contents of this file are subjected to the terms of the Common Development and Distribution
#License (the License).
# You may not use this file except in compliance with the License.
#
# You can obtain a copy of the license at usr/src/CDDL.txt
# or http://www.opensolaris.org/os/licensing.
# See the License for the specific language governing permissions
# and limitations under the License.
#
# When distributing Covered Code, include this CDDL HEADER in each
# file and include the License file at usr/src/CDDL.txt.
# If applicable, add the following below this CDDL HEADER, with the
# fields enclosed by brackets [] replaced with your own identifying
# information: Portions Copyright [yyyy] [name of copyright owner] Use is subject to license terms.
#
# CDDL HEADER END
#
#
#Copyright (c) 2006,2012, Oracle and/or its affiliates. All rights reserved.
#
# ident "@(#)rolechg_config.ksh 1.2 08/05/06"
#
# This file will be sourced in by rolechg_register and the parameters
# listed below will be used.
#
# These parameters can be customized in (key=value) form
#
# RS - name of the resource for the application.
# RG - name of the resource group containing RS.
# PORT - name of the port number.
# LH - name of the LogicalHostname SC resource.
# Do not set the LH variable if you plan to have a network
# unaware installation.
# HAS_RS - Name of the HAStoragePlus SC resource.
# STDBY_RS - The resource name of designated standby database
# PRI_RS - The resource name of designated primary database
# STDBY_HOST - Hostname or zonename of the standby host. If empty, a role switch
# will be initiated on any host.
# SDBY_PFILE - Parameter file which contains the PostgreSQL specific
# parameters for the standby database. This file is mentioned in
# the Start_command of the PostgreSQL standby resource.
# TRIGGER - The filename which will get created to tell pg_standby to end the
# recovery mode, this filename is mentioned in the recovery.conf file
# of the PostgreSQL standby database.
# WAIT - The number of seconds the start method waits before it touches
# the trigger file. This little break is necessary because, if the
# trigger file should be touched before, or in the middle of the
# PostgreSQL start process, it would get removed automatically.
RS=
RG=
PORT=
LH=
HAS_RS=
STDBY_RS=
PRI¯_RS=
STDBY_HOST=
STDBY_PFILE=
TRIGGER=
WAIT=