Editing Peer Node Groups

Use this task to edit a Peer Node Group.

When the Diameter > Configuration > Peer Node Groups [Edit] page opens, the fields are initially populated with the current values for the selected Peer Node Group.

  1. Select Diameter > Configuration > Peer Node Groups.

    The Diameter > Configuration > Peer Node Groups page appears.

  2. Select the Peer Node Group you want to edit, then click Edit.

    The Diameter > Configuration > Peer Node Groups [Edit] page appears.
    Note: The Peer Node Group Name field is read-only on this page.

  3. Update the relevant fields.

    For more information about each field, see Table 1.

  4. Click:
    • OK to save the changes and return to the Diameter > Configuration > Peer Node Groups page.
    • Apply to save the changes and remain on this page.
    • Cancel to return to the Diameter > Configuration > Peer Node Groups page without saving any changes.

    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • If one of the IP addresses exists in a different Peer Node Group
    • If the update will exceed the maximum number of Peer Nodes allowed
    • If the Peer Node is duplicated in the list
    • The selected Peer Node Group no longer exists; it has been deleted by another user
    • Any required field is empty; no value was entered or selected
    • The entry in any field is not valid (wrong data type or out of the valid range)
    • The selected pulldown list entry no longer exists (has been deleted by another user)

Parent topic: Peer Node Groups configuration