Editing an Address

Use this task to edit an address associated with a Routing Entity type.

  1. Select RBAR > Configuration > Addresses.

    The RBAR > Configuration > Addresses page appears.

  2. Select the Address you want to edit, then click Edit.

    Note: For details about locating an address, see Viewing Addresses.

    The RBAR > Configuration > Addresses [Edit] page appears.

  3. Update the relevant fields.

    For more information about each field, see Addresses configuration elements.
    The following fields are read-only and cannot be edited:
    • Routing Entity Type
    • Address Type

  4. Perform one of the following actions:
    • Click OK to save the changes and return to the RBAR > Configuration > Addresses page.
    • Click Apply to save the changes and stay on this page.
    • Click Cancel to return to the RBAR > Configuration > Addresses page without saving the changes.

    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Start Address is greater than the End Address
    • Start Address and End Address for an Address Range are overlapping or already exists
    • Address already exists for a Table Name
    • The entry in any field is not valid (wrong data type or out of the valid range)
    • Any required field is empty

Parent topic: Addresses configuration