Connect the Oracle FS System to the customer's management network by using Ethernet cables to connect the Pilots as part of the external cabling of the Oracle FS System.
Note: The system must be powered on with a status of Normal before you can connect to the customer management network.
CAUTION
Do not connect the
Pilot management interfaces to any network until after the global management configuration has been changed to match the external network.
The
Oracle FS System is shipped with the following default IP addresses and settings, with the Dynamic Host Configuration Protocol (DHCP) disabled. Before you connect the system to the customer management network, ensure that you have configured the management network to match the following settings:
- Default gateway
- 10.0.0.1
- Shared IP
- 10.0.0.2
- Pilot 1
- 10.0.0.3
- Pilot 2
- 10.0.0.4
- Netmask
- 255.255.255.0
- Auto-negotiation
- Enabled