Installation G&D-Winkel (adapted solution)
- In the following, you will be informed about how
to install a G&D Winkel (adapted solution). In an additional second
step, you will find out how to configure a Winkel-specific payment type
and assign it to the device.
- Go to System -> Configuration -> Device.
- Select the Device
type G&D
Winkel.
- Select the installation and the processing unit
to which you would like to assign the device.
- Enter a free Device
no..
- Enter a descriptor.
- Assign a COM interface in the field Device Interface (COM 1,
COM 2, COM A). It must not be occupied, otherwise there will be
a device conflict.
- Do not make any entries in the other input
fields. Accept the default values.
- Save the changes.
- Note:
The changes you made will only be valid after you re-run the system.
- Go to Parameters -> Payments -> Payment Type.
- Select the company to which the Winkel payment
type is to be assigned.
- Enter a free number in the field Payment Type.
- Enter a descriptor.
- Select the Category
EFT.
- Select the Eft
Type EFT 1.
- Enter “1”
in the field Eft Data.
- Select the usual decimal digits for the
currency.
- The other parameters are not to be edited.
- Open the sub-window Payment Parameter.
- Assign the new payment type to a terminal type.
- Determine the appropriate parameters, if
necessary.
- Close the window Payment Parameter.
- Save your entries.
MICROS Retail Deutschland GmbH
Salzufer 8
D-10587 Berlin
Germany