The Workstation 6 Series supports an optional biometric fingerprint module. The hex key is required for installation.
- Use the hex key to remove the screws from the top cover.
- Remove the top cover.
- Place the top cover in the position shown below.
- Loosen the screw to remove the dummy biometric cover.
- Insert the biometric module into the opening and connect the micro USB connector to the main PCB.
- Insert and tighten the screw to secure the biometric module.
- Close the top cover. Make sure the wires are not clamped by the cover.
- Use the hex key to reinsert the screws and to secure the top cover.