Reassembling the Workstation

  1. Place the rear cover over the system board and slide it toward the power button.
  2. Tighten the screws to secure the rear cover.


    This figure shows the location of the five screws on the back of the Workstation 6.

  3. Connect the RFID tag interface cable and the 8-pin modular cable for the magnetic stripe reader.


    This figure shows the 8-pin modular cable and the RFID tag.

  4. Slide in the magnetic stripe reader and tighten the two captive screws.


    This figures shows the location of the screws for the magnetic stripe reader.

  5. Connect the left and right speaker cables. Connect the speakers based on their orientation as shown.


    This figures shows the location of the speakers and speaker cables.

  6. Place the top cover and tighten the screws to secure the top cover.


    This figure shows the location of the security screws on the back of the Workstation 6.