Configuring the Fusebox Payment Card Driver

1. Select the Enterprise, property, or revenue center, click Setup, and then click Payment Drivers.
2. Insert a record, enter Fusebox as the name, and then click OK.
3. Double-click the record to open it.
4. On the General tab, click the Import from a file link.
5. Browse to [Drive Letter]:\MICROS\Simphony2\EgatewayService\handlers, select FuseboxPayment.dll, and then click Open.
6. Click the Configuration tab.
7. From the Assembly/Class section, enter information in the following fields:

   Table 12-13 Assembly/Class Fields

   Field	Description
   Description	Enter a description for the payment driver (for example, Fusebox Payment Driver).
   Display Name	Enter the name of the third-party driver development company (for example, Elavon). This value appears in the Driver drop-down list.
   Driver ID	Enter FB.

8. From the Common Driver Properties section, enter 1 in the following fields:

   • Bank Identification Number

   • Batch Number

   • Merchant Number

   • Store Number

   • Terminal Number

   The values in these fields cannot be 0 (zero) or blank.

9. From the Transport Service Properties section, enter information in the following fields:

   Table 12-14 Transport Service Properties Fields

   Field	Description
   Batching Host	If you are using the Fusebox solution, enter the IP address of the machine where the stunnel application is installed. If you are using ProtoBase, enter the IP address of the ProtoBase Hosted Solution provided by the Elavon representative for settlement transactions.
   Batching Host Port	Enter 10001 for Fusebox. Contact the Elavon representative for the ProtoBase Hosted Solution port number for settlement transactions.
   Host Timeout	Enter the timeout value in seconds. Setting the value to 0 (zero) equals no timeout. Do not leave this field blank.
   Primary Host	Enter the IP address of the machine that runs the stunnel application. If stunnel is installed per workstation, enter 127.0.0.1. If stunnel is installed on a single workstation at the property, leave this field blank. If the property is using ProtoBase, enter the IP address of the ProtoBase Hosted Solution provided by the Elavon representative for authorizations.
   Primary Host Port	Enter 10001 for Fusebox. Contact the Elavon representative for the ProtoBase Hosted Solution port number for authorizations.

10. From the Elavon Driver Properties section, enter information in the following fields:

    Table 12-15 Elavon Driver Properties Fields

    Field	Description
    Chain Code	Elavon assigns the six-character alphanumeric code, which is used for key management in gateway environments. The Chain Code is used with Fusebox, but not with ProtoBase.
    LocationName	If Elavon supplied a Location Name or Source IP Adress to pass from the POS client, enter it here. This value passes on every transaction and can be the location name or Fusebox workstation. You can leave this field blank. The LocationName is used with Fusebox, but not with ProtoBase.
    TerminationID	Enter the terminal code assigned by Elavon for the property to use with credit cards.
    TransactionInquiryRetryDelayTimeoutMS	Enter the amount of time Simphony waits before sending the request when a failure occurs. After a communication failure with Fusebox, Simphony sends an inquiry to Fusebox to discover the cause of failure. Oracle recommends entering 5000.

11. Click Save.