Network Insert elements

Table 4-2 describes the elements of the Networks Insert form.

Table 4-2 Networks Insert Elements

Field	Description	Data Input Notes
Network Name	The name of the network.	Must be unique. Format: String Range: 1-31 alphanumeric characters. Must start with a letter. No special characters are allowed. Defaut: n/a A value is required.
Network Type	The type of network in the context of the application.	Format: List Range: OAM or Signaling Default: OAM
VLAN ID	The VLAN ID of the Network	Format: Numeric Range: 1-4094 A value is required.
Network Address	The network address of the Network	Format: Valid network address Range: Dotted decimal (IPv4) or colon hex (IPv6) Default: n/a A value is required.
Netmask	Subnetting to apply to servers within the Network	Format: Valid network netmask Range: Prefix length (IPv4 or IPv6) or dotted quad decimal (IPv4) Default: n/a A value is required.
Router IP	The IP address of a router on this network. Note: If this is a default network, this i used as the gateway address of the default route on servers with interfaces on this network. If customer router monitoring is enabled, this address is the one monitored.	Format: Valid IP address Range: Dotted decimal (IPv4) or colon hex (IPv6) Default: n/a Note: A value is not required. Networks without a router IP cannot be used as the default network. The default network selection defaults to No.
Default Network	Whether the network is the default gateway	Format: Option Range: Yes or No
Routed	Whether the network is routed outside its network element. Note: The network is automatically assigned to a network element when a server in a network element has an IP from the network assigned is to it.	Format: Option Range: Yes or No Note: Select No to allow the same IMI network/IPs to be used at multiple Signaling sites.