Software Upgrade Procedure

The following procedure describes how to upgrade a Oracle® Enterprise Session Border Controller with a new software image. In this procedure, the image file is located on the Oracle® Enterprise Session Border Controller’s local file system in /boot.

To upgrade a software image on a stand-alone system:

1. Change the boot configuration parameters to use the new image.

   Scroll through the boot parameters by pressing Enter. Stop when you reach the file name boot parameter and type the appropriate file name next to the previous file name. Press <Enter> to continue scrolling through the boot parameters.

   The following example uses the filenames /boot/nnSCZ712.64.bz and /boot/nnSCZ720.64.bz.

   NETNETSBC1# configure terminal
   NETNETSBC1(configure)# bootparam
   '.' = clear field;  '-' = go to previous field;  ^D = quit
   boot device          : eth0
   processor number     : 0
   host name            : boothost
   file name            : /boot/nnSCZ712.64.bz /boot/nnSCZ720.64.bz
   [...]

2. Reboot the Oracle® Enterprise Session Border Controller using the reboot command.

   The Oracle® Enterprise Session Border Controller should now be successfully running the new release.