Managing LRT using the Show LRT Command

Existing ACLI show commands (show lrt and show lrt route-entry) commands have been enhanced to support DID ranges. A new command (show lrt route-table) displays the contents of a DID-range-based LRT.

show lrt now provides a count of valid and invalid route ranges as shown below.

ESD01# show lrt
14:43:03-64183
Name: lroute
Local Route Statistics       ---- Lifetime ----
                        Recent      Total     PerMax
Queries                      0          0          0
Result - Success             0          0          0
Result - Not found           0          0          0

Valid Route Entries:        19
Invalid Route Entries:       0
Valid Route Ranges          15                    // New to Version E-C[xz]6.4.0
Invalid Route Ranges         3                    // New to Version E-C[xz]6.4.0

show lrt route-entry displays matching DID ranges as follows.

ESD01# show lrt route-entry lroute 323
UserName <320-329>
            Entry Type = range
            NextHop = !^.*$!sip:3@public-range!
            NextHop Type = regexp
            Description = Test DID range

The new show lrt route-table displays a DID-range-based table as follows.

ESD01# show lrt route-table la 2
UserName <320-329>
        Entry Type = range
        NextHop = !^.*$!sip:3@public-range!
        NextHop Type = regexp
        Description = Test DID range

UserName <3123 - 3125>
        Entry Type = range
        NextHop = !^.*$!sip:1@public-range!
        NextHop Type = regexp 

Displaying 2 of 13 routes. Continue [y/n]?