HA Node Connection Configuration

If you are using HA, you need to set the phy-interface configuration parameters described in this section to establish successful connections. These parameters are for rear and media interfaces.

To access the phy-interface menu in the ACLI:

1. In Superuser mode, type configure terminal and press Enter.

   ORACLE# configure terminal

2. Type system and press Enter to access the system-level configuration elements.

   ORACLE(configure)# system

3. Type phy-interface and press Enter. The system prompt changes to let you know that you can begin configuring individual parameters.

   ORACLE(system)# phy-interface
   ORACLE(phy-interface)#

   From this point, you can configure phy-interface parameters. To view all phy-interface parameters, enter a ? at the system prompt.