Manual Trigger Configuration

This section shows you how to enable the manual trigger for sending session agents out of service, and how to then use the trigger from the command line. This section also shows you how to verify that you have successfully put a session agent out of service.

To enable a SIP session agent to manually trigger it to go out of service:

1. In Superuser mode, type configure terminal and press Enter.

   ORACLE# configure terminal
   ORACLE(configure)#

2. Type session-router and press Enter to access the signaling-level configuration elements.

   ORACLE(configure)# session-router
   ORACLE(session-router)#

3. Type session-agent and press Enter. The system prompt changes to let you know that you can begin configuring individual parameters.

   ORACLE(session-router)# session-agent
   ORACLE(session-agent)#

   If you are adding support for this feature to a pre-existing configuration, then you must select (using the ACLI select command) the configuration you want to edit.

4. invalidate-registrations—Set this parameter to enabled if you want to use the manual trigger to send this session agent offline (and therefore invalidate the registrations associated with it). The default is disabled.
5. Save and activate your configuration.

   To use the manual trigger that sends session agents offline:

6. Note the hostname value (typically the IP address of the endpoint) for the session agent you want to put out of service. You use this name as an argument in the ACLI command to use the manual trigger.
7. At the Superuser prompt, type reset session-agent, a Space, and the hostname value for the session agent. The press Enter.

   ORACLE# reset session-agent 192.168.20.45

   If you enter a session agent that does not exist, the system notifies you that it cannot carry out the reset.