Table 3-11 describes the information on the page:
Table 3-11 MTP3 Options Elements
Element | Description | Data Input Notes |
---|---|---|
Timer T1 | Changeover timer. This timer introduces a delay to help prevent message mis-sequencing on link changeover. |
Format: Numeric Range: 10 - 2000 msecs Default: 60 msecs |
Timer T3 | Change-back timer. This timer introduces a delay to help prevent message mis-sequencing on link change-back. |
Format: Numeric Range: 10 - 2000 msecs Default: 60 msecs |
Timer T6 | Controlled Rerouting timer. This timer introduces a delay to help prevent message mis-sequencing on controlled rerouting. |
Format: Numeric Range: 10 - 2000 msecs Default: 60 msecs |
Timer T10 | Destination Audit interval. This timer controls the interval at which RST/DAUD messages are sent when destination audit is activated. Destination audit is activated on receipt of a TFP/DUNA. If a TFA/DAVA is received, destination audit is deactivated. |
Format: Numeric Range: 1000 - 120000 msecs Default: 60000 msecs |
Timer T15 | Destination Congestion Test Delay. This timer controls the length of the wait before starting the signaling route set congestion test. |
Format: Numeric Range: 100 - 10000 msecs Default: 2000 msecs |
Timer T16 | Destination Congestion Test Timeout. This timer controls the length of the wait for the route set congestion status update. |
Format: Numeric Range: 100 - 10000 msecs Default: 1000 msecs |
SLS Rotation | This value specifies whether the SLS rotation procedure is enabled for egress messages. If SLS rotation is Enabled, the SLS value of messages is rotated before routing the messages to network. |
Format: List Range: Disabled, Enabled Default: Enabled |