Go to primary content
Diameter Signaling Router SS7/Sigtran
Release 8.2
E89009
Go To Table Of Contents
Contents

Previous
Previous
Next
Next

Inserting a Local Signaling Point

Use this procedure to insert an LSP.

  1. Click SS7/Sigtran > Configuration > Local Signaling Points.
  2. Click Insert.
  3. Populate the fields with data. For field definitions, see Local Signaling Points elements.
  4. Click OK, Apply, or Cancel.
    If OK or Apply is clicked and any of the following conditions exists, an error message appears:
    • Any fields contain a value that is out of the allowed range
    • Any required field is empty (not entered)
    • Adding a Server Group would cause the maximum number of Server Groups per LSP (1) to be exceeded
    • The Local Signaling Point Name field value already exists
    • A Server Group added to the list of Server Groups no longer exists (has been deleted)
    • A Server Group added to the list of Server Groups does not have at least one Server assigned to it
    • The MTP True Point Code was already assigned to another LSP (by another user)
    • The MTP Capability Point Code already exists as an MTP Capability Point Code for this LSP
    • The MTP Capability Point Code already exists as an MTP True Point Code
    • Any of the MTP Capability Point Code check boxes is checked, but the corresponding MTP Capability Point Code value was not entered
    • Adding this Local Signaling Point would cause the maximum number of Local Signaling Points per site (10) to be exceeded