Inserting a Transport Manager Configuration Set

Use this task to configure a new Transport Manager Configuration Set.

The fields are described in Transport Manager Configuration Set elements.

1. Select Transport Manager > Configuration > Configuration Sets.
2. Click Insert.
   The default values that appear on the Transport Manager Configuration Set [Insert] page match whatever values are configured in the Default Transport Manager Configuration Set. The original default values are shown in Transport Manager Configuration Set elements.
3. Populate the fields with data. For field definitions, see Transport Manager Configuration Set elements.
4. Perform one of these actions:
   • Click OK to save the data and exit this page.
   • Click Apply to save the data and remain on this page.
   • Click Cancel to exit this page without saving any data.
   When OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Any field contains a value that is not valid or is out of the allowed range.
   • Any required field is empty (not entered).
   • A value that must be unique is not unique.
   • The Retransmit Minimum Timeout value is greater than Retransmit Maximum Timeout value.
   • The Retransmit Maximum Timeout value is less than Retransmit Minimum Timeout value.
   • Adding the new Configuration Set would cause the maximum number of Configuration Sets per system (20) to be exceeded.

The Transport Manager Configuration Set is added.