Editing a Transport Manager Configuration Set

Use this task to edit a Transport Manager Configuration Set.

Note:

Although the Default Transport Manager Configuration Set can be edited, any changes to the default values should be evaluated carefully. The default values shown in Transport Manager Configuration Set elements are recommended.

A Configuration Set that is referenced by an active (Enabled) Transport cannot be edited. To disable a Transport, see Disabling a Transport.

1. Select Transport Manager > Configuration > Configuration Sets.
2. Click Edit next to the Transport Manager Configuration Set you wish to modify.
   A Configuration Set Name cannot be changed.
3. Make the desired changes. For field definitions, see Transport Manager Configuration Set elements.
4. Perform one of these actions:
   • Click OK to save the data and exit this page.
   • Click Apply to save the data and remain on this page.
   • Click Cancel to exit this page without saving any data.
   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Any field contains a value that is not valid or is out of the allowed range.
   • Any required field is empty (not entered).
   • A value that must be unique is not unique.
   • The edited entry no longer exists (has been deleted by another user).
   • The Retransmit Minimum Timeout value is greater than Retransmit Maximum Timeout value.
   • The Retransmit Maximum Timeout value is less than Retransmit Minimum Timeout value.
   • The Transport Admin State could not be obtained from the MP server: Refer to the Status & Manage > Server GUI page for possible causes.

The Transport Managers Configuration Set is updated. For the changes to take effect, the disabled Transport Manager must be placed back into service (see Enabling a Transport).