Global Response

The Equipment Identity Register (EIR) provides an EirOptions table to configure the global response type (eirGlobalResp). If this option is set to on, then a checkIMEI response is sent to the MSC. By default, the eirGlobalResp option within EIR is set to off. If you leave it off, this order determines the equipment status.

1. IMSI range screening.
2. IMEI and IMEI range screening.
3. SV screening where the last two digits of IMEI are used for the software version.
4. IMSI exact match.

The attribute or parameter follows these rules for its name:

• Common parameters for SS7 and Diameter have an "eir" prefix.
• Diameter-specific parameters have a "diameter" prefix.
• Specific parameters have an "ss7" prefix.

The EIR attributes/parameter included in EIR are listed in Table 3-1.

Table 3-1 Attribute/Parameter Mapping

Attribute/Parameter Name	Description	Default Value	Valid Values or Range
ss7DefMapVer	Map version to decode message	V3	V1, V2, V3
eirDefMcc	E212 default mobile country code.	None	XXX (X = 0-9, A-F,a-f )
eirDefMnc	E212 default mobile network code.	None	XX or XXX (X = 0-9, A-F,a-f )
eirDefImsiResp	EIR default IMSI response. Note: When IMSI lookup is successful, this parameter defines the IMSI override lookup response.	Whitelist	Whitelist, Blacklist, Graylist, Unknown
eirGlobalResp	EIR Global Response status.	Off	Off, Whitelist, Blacklist, Graylist, Unknown
eirDefResp	EIR default response status (used when UDR connectivity is down) Note: If this parameter is set to on, then the IMSI response is used; otherwise, equipment status is set based on the IMEI lookup.	Whitelist	Whitelist, Blacklist, Graylist, Unknown
eirImsiChk	EIR IMSI Check status. This parameter is not valid for IMEI ranges.	false	true, false
eirRespType	EIR Response Type.	Type1	Type1, Type2, Type3
eirImsiScrn	EIR IMSI range screening. Search IMSI in IMSI range table.	true	true, false
diameterCongErr	Value in the ‘result code’ AVP of the response send, at the time of Congestion.	3004	3004, 5006
diameterVendorId	S13 local Vendor ID. All the outgoing messages that require Vendor ID in VENDOR_SPECIFIC_APPLICATION_ID will use this configured value. Currently only 10415 is supported.	10415	10415
diameterProductName	Product Name. It contains the vendor-assigned name for the product. All the outgoing messages that require Product name AVP will use this configured value.	DSR	DSR