SIP maddr Resolution Configuration

To configure the Oracle® Enterprise Session Border Controller to perform SAG-based maddr resolution:

1. From superuser mode, use the following command sequence to access sip-config configuration mode. While in this mode, you configure SAG-based address resolution.

   ORACLE# configure terminal
   ORACLE(configure)# session-router
   ORACLE(session-router)# sip-config
   ORACLE(sip-config)#

2. Use the sag-lookup-on-redirect parameter to enable SAG-based maddr resolution.
3. Use done, exit, and verify-config to complete SAG-based address resolution.