Oracle® Communications EAGLE Database Administration - SS7 User's Guide Release 46.7 E97335 Revision 1 |
|
![]() Previous |
![]() Next |
This procedure is used to remove an E1 interface from the database using the dlt-e1
command using these parameters.
:loc
– The location of the E1 card (card type lime1
) containing the E1 interface being removed.
:e1port
– The E1 port on the E1 card containing the E1 interface being removed.
The E1 interface to be removed must exist in the database. This can be verified in step 1.
To remove the E1 interface information contained on an E1 card, all signaling links serviced by that E1 card must be removed from the database. This can be verified with the rtrv-e1
command, specifying the card location and E1PORT
on the E1 card, and the rtrv-slk
command, specifying the location of any cards (E1 or channel cards) shown in the rtrv-e1
output. If there are any signaling links being serviced by the E1 card, go to the Removing an SS7 Signaling Link procedure and remove these signaling links.
Even numbered E1 ports cannot be removed if the even numbered E1 port is channel bridged. Remove the corresponding odd numbered E1 port (see Table A-5) to remove the even numbered channel bridged E1 port.
Figure A-9 Removing the E1 Interface Parameters