Card Alarms
Table A-3 shows the critical, major, and minor card alarms and the clearing alarm that appears when each condition is resolved.
Table A-3 Card Alarms
UAM | Text | UAM | Text |
---|---|---|---|
Critical | Normal | ||
0077 | Card temperature is critical lvl:T2 | 0079 | Card temperature again at nominal levels |
0092 | MDAL not responding | 0093 | MDAL alarm cleared |
0127 | ENUM card capacity exceeded | 0126 | ENUM Threshold Condition cleared |
0442 | RTDB database capacity is 95% full | 0447 | RTDB database capacity alarm cleared |
Major | Normal | ||
0001 | Card has reset | 0014 | Card is present |
0096 | Card has been reloaded | ||
0008 | Active MASP has become isolated | 0009 | MASP became active |
0010 | MASP became standby | ||
0012 | Invalid HW for Integrated Measurements | 0519 | Measurements subsystem available |
0013 | Card is isolated from the system | 0014 | Card is present |
0096 | Card has been reloaded | ||
0031 | HIPR2 detected a major Congested Second | 0032 | HIPR2 Congestion cleared |
0053 | Standby TDM failure | 0054 | Standby TDM failure cleared |
0078 | Card temperature exceeds nominal lvl:T1 | 0079 | Card temperature again at nominal levels |
0088 | Clocks A and B TSCs are out of sync | 0089 | Clocks A and B TSCs are re-synchronized |
0125 | ENUM Threshold -Level 2 exceeded | 0126 | ENUM Threshold Condition cleared |
0132 | Loading failed: table not found | 0096 | Card has been reloaded |
0133 | Loading failed: data read error | ||
0134 | Loading failed: bad checksum returned | ||
0135 | Loading failed: GPL load timeout | ||
0136 | Loading failed: data load timeout | ||
0137 | Loading failed: invalid GPL | ||
0138 | Loading failed: GPL format error | ||
0139 | Loading failed: disk read prep error | ||
0140 | Loading failed: disk read response error | ||
0141 | Loading failed: disk read failed | ||
0300 | TVG Grant Failure | 0301 | TVG Grant Recovery |
0306 | SNM Overload Onset | 0307 | SNM Overload Abated |
0043 | Incorrect feature configuration | 0423 | Card reload attempted |
0047 | Card type not valid for application | ||
0099 | Incompatible HW for provisioned slot | ||
0276 | Insufficient HW for IP7 provisioning | ||
0297 | Incorrect port configuration | ||
0422 | Insufficient extended memory | ||
0441 | Incorrect MDB – CPU | ||
0446 | RTDB database capacity is 80% full | 0447 | RTDB database capacity alarm cleared |
0449 | RTDB re-synchronization in progress | 0445 | RTDB database has been corrected |
0500 | Alarm for this entity is being cleared | ||
0443 | RTDB database is corrupted | 0445 | RTDB database has been corrected |
0451 | RTDB reload is required | ||
0514 | Standby MASP is inhibited | 0515 | Standby MASP is allowed |
0901 | Card DB load timeout, check GLS card | 0902 | Card DB is stable |
0903 | IP Link A is down | 0904 | IP Link A is up |
0905 | IP Link B is down | 0906 | IP Link B is up |
0908 | HW cannot support purchased TPS rate | 0907 | HW limiting TPS rate alarm cleared |
0051 | TSC Sync is in simplex mode | 0052 | TSC sync feature is available |
0466 | STC Network Unavailable | 0467 | STC Network Available |
0088 | Clocks A and B TSCs are out of sync | 0089 | Clocks A and B TSCs are re-synchronized |
0390 | Illegal Address Error | 0388 | Illegal Address Error Cleared |
0391 | Card not responding Error | 0389 | Card responding normally |
0573 | BERT Test Failed | 0574 | BERT Test Passed |
0575 | Card type not HIPR2 | 0500 | Alarm for this entity is being cleared |
0548 | GTT HexTree DB corrupted. TPS derated | 0550 | GTT HexTree DB alarm cleared |
0549 | GTT HexTree DB incoherent. TPS derated | ||
Minor | Normal | ||
UAM | Text | UAM | Text |
0022 | Clock B for card failed, Clock A normal | 0025 | Clock B for card normal |
0023 | Clocks A and B for card failed | 0026 | Clocks A and B for card normal |
0030 | HIPR2 detected a minor Congested Second | 0032 | HIPR2 Congestion cleared |
0034 | Card database is inconsistent | 0033 | Card database has been corrected |
0035 | Card database is corrupted | ||
0037 | Card backup database is inconsistent | 0036 | Card backup database has been corrected |
0038 | Card backup database is corrupted | ||
0044 | Real time clock battery low | 0045 | Real time clock battery restored |
0055 | Persistent device state tbl corrupt | 0057 | Persistent device state tbl corrected |
0056 | Persistent device state tbl diff ver | ||
0102 | Motherboard BIP invalid | 0103 | Motherboard BIP valid |
0124 | ENUM Threshold -Level 1 exceeded | 0126 | ENUM Threshold Condition cleared |
0145 | HS Clock A for card failed, B normal | 0148 | High Speed Clock A for card normal |
0146 | HS Clock B for card failed, A normal | 0149 | High Speed Clock B for card normal |
0147 | High Speed Clocks A and B for card failed | 0159 | High Speed Clocks A and B for card normal |
0298 | Card not using config. SCTP csum method | 0299 | Config. SCTP csum method alarm cleared |
0304 | REPT-NMTSK-DSCD: SNM Discard Onset | 0305 | RECVY-NMTSK-DSCD: SNM Discard Abated |
0444 | RTDB database is inconsistent | 0445 | RTDB database has been corrected |
0448 | RTDB database incoherent | ||
0466 | STC Network Unavailable | 0467 | STC Network Available |
0480 | Timestamp Invalid | 0481 | Timestamp Valid |
0498 | Sanity monitoring is disabled | 0499 | Sanity monitoring is enabled |
0130 | Card successfully loaded with data | ||
0400 | Alarm cleared by deleting card | ||
0294 | REPT-ALMINH: alarm output PERM inhibit | ||
0295 | REPT-ALMINH: alarm output enabled | ||
0296 | REPT-ALMINH: alarm output TEMP inhibit | ||
0570 | Incompatible flash image for sys rel | 0423 | Card reload attempted |
0579 | FC Network Unavailable | 0580 | FC Network Available |
0581 | Loss of heartbeat | 0582 | Heartbeat Available |
0590 | Fast Copy Application De-activated | 0591 | Fast Copy Application Activated |