Sample Traffic Policy Configuration

The following formatted extract from traffic-policy-config shows the default policy configuration.

Note:

For this initial release of software, if you do not need to change any of the implicit defaults for the traffic policy, you do not need to configure this policy at all. The implicit default configuration for this policy is as below. If you need to change any of the parameters from the implicit default, you must name the resulting traffic policy default

SLB1(traffic-policy-config)# show
traffic-policy-config
        name                                    default
        throttle-rate                           800
        max-signaling-rate                      33000000
        min-untrusted-pct                       10
        max-untrusted-pct                       30
        options