E4483 Cmd Rej: PC does not exist in specified MRNSET

For the chg-sccp-serv and dlt-sccp-serv commands, the specified point code must already exist in the specified MRNSET portion of the SCCP-SERV table.

For the ent/chg-gta, ent/chg-gtt, and ent/chg-gttact commands, if the Flexible GTT Load Sharing (FGTTLS) feature is enabled, then the specified point code must already exist in the specified MRN set.

For the ent/chg-map commands, the value specified for the mrnpc parameter must already exist in the specified MRN Set.

For the ent/chg/dlt/rtrv-mrn commands, the specified point code must already exist in the MRN set.

Recovery

1. Display the point codes in the MRN table. Enter the rtrv-mrn command.
2. Display the status of the FGTTLS feature if necessary. Enter the rtrv-ctrl-feat command.
   If the feature does not appear in the output, then the feature is not enabled. If the feature has a status of OFF, then the feature is enabled but is not turned on.
3. Add point codes to the MRN table as necessary. Refer to the Commands User's Guide and to the Database Administration - GTT User's Guide to for assistance.
4. Re-enter the command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide and to the Database Administration - GTT User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).