E2603 Cmd Rej: Card must be inhibited before executing this command

The specified card (other than OAM locations) must be in the OOS-MT-DSBLD (out of service - maintenance disabled) state before this command can be entered.

If the location specified by the loc parameter is an OAM card location, then the command can be entered while the card is IN-SR status (as DB modifications are not allowed while the OAM is inhibited). However, the card needs to be re-initialized after the command for the changes to take effect.

For the ent-slk command, the E5-ATM or E5-ATM-B card must be in the OOS-MT-DSBLD state before the card can support an A1 link.

Note:

This error message does not apply to HMUX, HIPR, or HIPR2 MUX cards for the init-flash command.

Recovery

1. Display the status of the card that generated this error message. Enter the rept-stat-card command, specifying the card location.
   The primary state of the card is shown in the PST field.
2. Change the primary state of the card to OOS-MT-DSBLD as necessary. Refer to the Maintenance Guide for assistance.
3. Re-enter the command that generated this error message.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).