E2379 Cmd Rej: Missing parameter

Table 2-4 describes the parameter combinations that must be entered.

Table 2-4 Required Command and Parameter Combinations

Command	Missing Parameter
chg-ee-card	If the fltid parameter is specified, then the action parameter must be specified.
dbg-ddb	If the action parameter has a value of disp, aud, stats, or wwa, then the loc parameter must be specified. If the action=aud and the rloc parameter are specified, then the audtype parameter must be specified. If the action parameter has a value of disp or aud, then the tbl parameter must be specified.
ent-ee-flt	If the sctpstr parameter is specified, then the stype=data and ipprot=sctp parameters must be specified.
ent/chg-gttact	If a value of dup or fwd is specified for the act parameter, then the pc/pca/pci/pcn/pcn24/pcn16 parameter must be specified. If the ri=ssn parameter is specified, then the ssn parameter must be specified. If the cgpcogmsg=provcgpc parameter is specified, then the cgpc/cgpca/cgpci/cgpcn/cgpcn24/cgpcn16 parameter must be specified. The sprm and tprm parameters must be specified when act is set to scpval.
ent/dlt/rtrv-pct	If the ssn or ecics parameter is specified, then the si parameter must be specified. If the rcics parameter is specified, then the ecics parameter must be specified. If the ecics, ecice, and rcics parameters are specified, then the rcice parameter must be specified. If the ecics, rcics, and rcice parameters are specified, then the ecice parameter must be specified. For the ent-pct command, the ecics parameter must be specified before the relcause parameter can be specified. For the rtrv-pct command, the epc/epca/epci/epcn or realpc/realpca/realpci/realpcn parameter must be specified if any other optional parameter is specified.
ent-slk	If a card location is specified for a Channel card (card type limch) assigned to an E1 interface, then the e1loc parameter must be specified. If a card location is specified for a Channel card (card type limch) assigned to a T1 interface, then the t1loc parameter must be specified. If a card location is specified for an E1, T1, or Channel card (card type lime1, limt1, or limch), then the ts parameter must be specified for the link.
rept-stat-slk	This command can be entered with the stat parameter or the loc and port/link parameters. If the stat parameter is specified, it must be specified by itself. If the loc parameter is specified, the port/link parameter must be specified. If the port/link parameter is specified, the loc parameter must be specified. Class criteria cannot be specified without dpc parameter.

Recovery

Re-enter the command that generated this error message, specifying a valid set of parameters. Refer to the command description in Commands User's Guide for more information.