E3513 Cmd Rej: Invalid parameter combination with PERDATA param

For the init-card command, the perdata parameter can be specified only when the loc or appl parameter is specified along with the data=persist parameter. In addition, the type parameter cannot be specified with the perdata parameter.

Note:

The card at the location specified by the loc parameter must run either the IPSG32 GPL or the VSCCP application, and the application specified by the appl parameter must be either IPSG or VSCCP.

For the init-sys command, the perdata parameter can be specified only when the data parameter is specified.

Recovery

Re-enter the command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide for assistance.

Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).