E3921 Cmd Rej: ITU National Point Code must be full point code

ANSI point code value 000-000-000 and ITU-International point code value 0-000-0 are not allowed.

The ITU-National point code must be a full point code. A full point code is specified with a numerical value for the nnnnn segment of the point code.

If the ITUDUPPC (ITU national duplicate point code) feature is on, then the ITU national point code will also contain a group code. The group code is a two-character field from aa to zz that is entered as the last subfield of an ITU-N point code, nnnnn-gc (for example, 2112-aa).

Note:

Once a feature this is controlled using a feature bit has been turned on, it cannot be turned off.

A flexible point code format can be assigned with the chg-stpopts:npcfmti parameter. Refer to the command description for the chg-stpopts command in Commands User's Guide for assistance.

An asterisk (*) cannot be used to enter or change ITU national point codes. The asterisk is allowed only for retrieving ITU national point codes.

Recovery

1. Display the status of the ITUDUPPC feature. Enter the rtrv-feat command.
2. Re-enter the command that generated this error message, specifying a valid combination of parameters. Refer to the command description in Commands User's Guide for assistance.
   Contact My Oracle Support if this error message appears again. See My Oracle Support (MOS).