0217 - REPT-LKF: XDA - excess acknowledge delay

The T7 timer has timed out. Either there is too much incoming traffic on M2PA signaling links, or the far end node is taking too long to acknowledge the messages sent to it by the signaling terminal.

Example

   RLGHNCXA21W 00-12-07 12:01:43 EST  EAGLE 35.0.0 
** 0014.0217 ** SLK 1205,A nc00027  REPT-LKF: XDA-excess acknowledge delay
                SLC=03   FECLLI=testclli            CLASS=MTP2

Note:

The Class parameter in the example is optional.

Alarm Level: Major

Recovery

1. Enter rept-stat-card:mode=full:loc=xxxx to determine if the signaling link is M2PA. If so, continue to 2. If not, skip to 3.
2. If this alarm is raised for M2PA signaling links, do the following:
   1. Enter the rept-stat-iptps and msucount –l commands to determine how much traffic is received and transmitted on the M2PA links.
   2. Enter the rtrv-ls command to determine the amount of rsvdslktps and maxslktps traffic that the M2PA signaling link can receive based on what is provisioned. (The rsvdslktps is the reserved-per-signaling-link TPS for IPSG linkset; this indicates the minimum guaranteed capacity for each link in the linkset. The maxslktps is the maximum-per-signaling-link TPS; this indicates the maximum traffic permitted when sufficient unused capacity is present on the host card.)
   3. If the value is incorrect to handle the incoming traffic rate, enter the chg-ls command to increase or decrease the minimum and maximum TPS for the M2PA signaling link.
3. If the problem persists, follow local procedures to determine why the far end is not responding correctly.