0048 - Terminal Failed

The MASP has detected that the terminal is faulty. The maintenance software has removed the terminal from service.

Example

  RLGHNCXA21W 00-02-07 12:01:43 EST  EAGLE 35.0.0
* 0014.0048  * TERMINAL   15       Terminal failed

Alarm Level: Minor

Recovery

1. Verify that the power to the terminal is on and that the terminal is physically connected to the control shelf backplane.
   If the fault does not clear, disconnect the terminal from the control shelf backplane and connect another terminal (with the same communication attributes as the old terminal) to the same port on the control shelf backplane.
2. Enter the following command to verify the communication attributes of the terminal port:
   rtrv-trm
3. If the communication attributes need to be changed, refer to the Commands Manual and enter the following command with the appropriate parameters to make the required changes to the communication attributes:
   chg-trm
4. Terminals are connected to ports on the TDM card.

   Enter the following command to determine which ports are idle:

   rept-stat-user
5. Move the terminal to another port on the TDM card or on the backplane.
   If the fault does not clear, replace the TDM card. Refer to the Maintenance Manual for card removal/replacement procedures.