Card Alarms
Table A-3 shows the critical, major, and minor card alarms and the clearing alarm that appears when each condition is resolved.
Table A-3 Card Alarms
| UAM | Text | UAM | Text |
|---|---|---|---|
| Critical | Normal | ||
| 0077 | Card temperature is critical lvl:T2 | 0079 | Card temperature again at nominal levels |
| 0092 | MDAL not responding | 0093 | MDAL alarm cleared |
| 0127 | ENUM card capacity exceeded | 0126 | ENUM Threshold Condition cleared |
| 0442 | RTDB database capacity is 95% full | 0447 | RTDB database capacity alarm cleared |
| Major | Normal | ||
| 0001 | Card has reset | 0014 | Card is present |
| 0096 | Card has been reloaded | ||
| 0008 | Active MASP has become isolated | 0009 | MASP became active |
| 0010 | MASP became standby | ||
| 0012 | Invalid HW for Integrated Measurements | 0519 | Measurements subsystem available |
| 0013 | Card is isolated from the system | 0014 | Card is present |
| 0096 | Card has been reloaded | ||
| 0031 | HIPR2 detected a major Congested Second | 0032 | HIPR2 Congestion cleared |
| 0053 | Standby TDM failure | 0054 | Standby TDM failure cleared |
| 0078 | Card temperature exceeds nominal lvl:T1 | 0079 | Card temperature again at nominal levels |
| 0088 | Clocks A and B TSCs are out of sync | 0089 | Clocks A and B TSCs are re-synchronized |
| 0125 | ENUM Threshold -Level 2 exceeded | 0126 | ENUM Threshold Condition cleared |
| 0132 | Loading failed: table not found | 0096 | Card has been reloaded |
| 0133 | Loading failed: data read error | ||
| 0134 | Loading failed: bad checksum returned | ||
| 0135 | Loading failed: GPL load timeout | ||
| 0136 | Loading failed: data load timeout | ||
| 0137 | Loading failed: invalid GPL | ||
| 0138 | Loading failed: GPL format error | ||
| 0139 | Loading failed: disk read prep error | ||
| 0140 | Loading failed: disk read response error | ||
| 0141 | Loading failed: disk read failed | ||
| 0300 | TVG Grant Failure | 0301 | TVG Grant Recovery |
| 0306 | SNM Overload Onset | 0307 | SNM Overload Abated |
| 0043 | Incorrect feature configuration | 0423 | Card reload attempted |
| 0047 | Card type not valid for application | ||
| 0099 | Incompatible HW for provisioned slot | ||
| 0276 | Insufficient HW for IP7 provisioning | ||
| 0297 | Incorrect port configuration | ||
| 0422 | Insufficient extended memory | ||
| 0441 | Incorrect MDB – CPU | ||
| 0446 | RTDB database capacity is 80% full | 0447 | RTDB database capacity alarm cleared |
| 0449 | RTDB re-synchronization in progress | 0445 | RTDB database has been corrected |
| 0500 | Alarm for this entity is being cleared | ||
| 0443 | RTDB database is corrupted | 0445 | RTDB database has been corrected |
| 0451 | RTDB reload is required | ||
| 0514 | Standby MASP is inhibited | 0515 | Standby MASP is allowed |
| 0901 | Card DB load timeout, check GLS card | 0902 | Card DB is stable |
| 0903 | IP Link A is down | 0904 | IP Link A is up |
| 0905 | IP Link B is down | 0906 | IP Link B is up |
| 0908 | HW cannot support purchased TPS rate | 0907 | HW limiting TPS rate alarm cleared |
| 0051 | TSC Sync is in simplex mode | 0052 | TSC sync feature is available |
| 0466 | STC Network Unavailable | 0467 | STC Network Available |
| 0088 | Clocks A and B TSCs are out of sync | 0089 | Clocks A and B TSCs are re-synchronized |
| 0390 | Illegal Address Error | 0388 | Illegal Address Error Cleared |
| 0391 | Card not responding Error | 0389 | Card responding normally |
| 0573 | BERT Test Failed | 0574 | BERT Test Passed |
| 0575 | Card type not HIPR2 | 0500 | Alarm for this entity is being cleared |
| 0548 | GTT HexTree DB corrupted. TPS derated | 0550 | GTT HexTree DB alarm cleared |
| 0549 | GTT HexTree DB incoherent. TPS derated | ||
| Minor | Normal | ||
| UAM | Text | UAM | Text |
| 0022 | Clock B for card failed, Clock A normal | 0025 | Clock B for card normal |
| 0023 | Clocks A and B for card failed | 0026 | Clocks A and B for card normal |
| 0030 | HIPR2 detected a minor Congested Second | 0032 | HIPR2 Congestion cleared |
| 0034 | Card database is inconsistent | 0033 | Card database has been corrected |
| 0035 | Card database is corrupted | ||
| 0037 | Card backup database is inconsistent | 0036 | Card backup database has been corrected |
| 0038 | Card backup database is corrupted | ||
| 0044 | Real time clock battery low | 0045 | Real time clock battery restored |
| 0055 | Persistent device state tbl corrupt | 0057 | Persistent device state tbl corrected |
| 0056 | Persistent device state tbl diff ver | ||
| 0102 | Motherboard BIP invalid | 0103 | Motherboard BIP valid |
| 0124 | ENUM Threshold -Level 1 exceeded | 0126 | ENUM Threshold Condition cleared |
| 0145 | HS Clock A for card failed, B normal | 0148 | High Speed Clock A for card normal |
| 0146 | HS Clock B for card failed, A normal | 0149 | High Speed Clock B for card normal |
| 0147 | High Speed Clocks A and B for card failed | 0159 | High Speed Clocks A and B for card normal |
| 0298 | Card not using config. SCTP csum method | 0299 | Config. SCTP csum method alarm cleared |
| 0304 | REPT-NMTSK-DSCD: SNM Discard Onset | 0305 | RECVY-NMTSK-DSCD: SNM Discard Abated |
| 0444 | RTDB database is inconsistent | 0445 | RTDB database has been corrected |
| 0448 | RTDB database incoherent | ||
| 0466 | STC Network Unavailable | 0467 | STC Network Available |
| 0480 | Timestamp Invalid | 0481 | Timestamp Valid |
| 0498 | Sanity monitoring is disabled | 0499 | Sanity monitoring is enabled |
| 0130 | Card successfully loaded with data | ||
| 0400 | Alarm cleared by deleting card | ||
| 0294 | REPT-ALMINH: alarm output PERM inhibit | ||
| 0295 | REPT-ALMINH: alarm output enabled | ||
| 0296 | REPT-ALMINH: alarm output TEMP inhibit | ||
| 0570 | Incompatible flash image for sys rel | 0423 | Card reload attempted |
| 0579 | FC Network Unavailable | 0580 | FC Network Available |
| 0581 | Loss of heartbeat | 0582 | Heartbeat Available |
| 0590 | Fast Copy Application De-activated | 0591 | Fast Copy Application Activated |