Global Response
The Equipment Identity Register (EIR) provides an EirOptions table to
configure the global response type (eirGlobalResp). If this option is set to
on, then a checkIMEI response is sent to the MSC. By
default, the eirGlobalResp option within EIR is set to
off. If you leave it off, this order determines the
equipment status.
- IMSI range screening.
- IMEI and IMEI range screening.
- SV screening where the last two digits of IMEI are used for the software version.
- IMSI exact match.
The attribute or parameter follows these rules for its name:
- Common parameters for SS7 and Diameter have an "eir" prefix.
- Diameter-specific parameters have a "diameter" prefix.
- Specific parameters have an "ss7" prefix.
The EIR attributes/parameter included in EIR are listed in Table 3-1.
Table 3-1 Attribute/Parameter Mapping
| Attribute/Parameter Name | Description | Default Value | Valid Values or Range |
|---|---|---|---|
| ss7DefMapVer | Map version to decode message | V3 | V1, V2, V3 |
| eirDefMcc | E212 default mobile country code. | None | XXX (X = 0-9, A-F,a-f ) |
| eirDefMnc | E212 default mobile network code. | None | XX or XXX (X = 0-9, A-F,a-f ) |
| eirDefImsiResp |
EIR default IMSI response. Note: When IMSI lookup is successful, this parameter defines the IMSI override lookup response. |
Whitelist | Whitelist, Blacklist, Graylist, Unknown |
| eirGlobalResp | EIR Global Response status. | Off | Off, Whitelist, Blacklist, Graylist, Unknown |
| eirDefResp |
EIR default response status (used when UDR connectivity is down). Note: If this parameter is set to
|
Whitelist | Whitelist, Blacklist, Graylist, Unknown |
| eirImsiChk | EIR IMSI Check status. This parameter is not valid for IMEI ranges. | false | true, false |
| eirRespType | EIR Response Type. | Type1 | Type1, Type2, Type3 |
| eirImsiScrn | EIR IMSI range screening. Search IMSI in IMSI range table. | true | true, false |
| diameterCongErr | Value in the ‘result code’ AVP of the response send, at the time of Congestion. | 3004 | 3004, 5006 |
| diameterVendorId | S13 local Vendor ID. All the outgoing messages that require Vendor ID in VENDOR_SPECIFIC_APPLICATION_ID will use this configured value. Currently only 10415 is supported. | 10415 | 10415 |
| diameterProductName | Product Name. It contains the vendor-assigned name for the product. All the outgoing messages that require Product name AVP will use this configured value. | DSR | DSR |
