Configuring a Chip and PIN Reader

OPERA Controls – Credit Card Group

  • Chip and PIN parameter

OPERA Tasks – Interfaces Admin

  • Property Interfaces

    • Chip and PIN Terminal Setup

  1. From the Administration menu, select Interfaces, select Interface Devices, and then select Credit Card Terminals.
  2. Click New.
  3. Enter the following information for the reader:
    Terminal ID: Enter the terminal ID number provided by the vendor. You can also locate this number on the actual card reader device.
    Terminal Label: Enter a label or description for the terminal/device that identifies its physical location. This helps you easily identify the terminal/device when it appears in a list of devices.
  4. Click Save.