USM Base Configuration Elements for LST

This appendix provides configuration samples of the elements that are required for minimal Oracle USM operation.

The SIP Config must be enabled

sip-config state enabled

You must have a default gateway in your system-config

system-config default-gateway 10.0.0.1

You must have an access physical interface

phy-interface name s0p0 operation-type Media port 0 slot 0

You must have an access network interfaces

network-interface name s0p0 sub-port-id 0 ip-address 192.170.1.100 netmask 255.255.255.0 gateway 192.170.1.1

You must have an access realm

realm-config identifier access1 addr-prefix 0.0.0.0 network-interfaces s0p0:0

You must have an access SIP interface

sip-interface state enabled realm-id access1 sip-port address 192.170.1.100 port 5060 transport-protocol UDP allow-anonymous registered trust-mode none registration-caching enabled ims-access enabled

You must have a Local Subscriber Table

local-subscriber-table name My_LST filename /code/lst/My_LST.xml secret *******

You must have an Authentication Profile

sip-authentication-profile name My_Auth_Profile methods REGISTER anonymous-methods * digest-realm My_Digest_Realm.com credential-retrieval-method local credential-retrieval-config My_LST

You must have a Sip-Registrar

sip-registrar name My_Registrar_Name domains my_customer1.com subscriber-database-method LOCAL subscriber-database-config My_LST.xml authentication-profile My_Auth_Profile routing-precedence REGISTRAR