Configuring the Integration Hub

To configure and enable the Integration HUB link:

  1. For the nodes that will be defined in the network, set up Single Sign-on. See Implementing PeopleSoft-Only Single Signon.

  2. Perform a successful network ping from each pillar that is defined in the network (or at least where the Integration HUB will be used). See Using the Network Status Page.

  3. For the end user to have access to the Integration Hub page, insure that the user(s) are added to the following permission lists - PTPT1200 and PTPT1000. See Using the Service Operation Permissions Page.

  4. Ensure that the default local node and the Portal node(s) on each pillar defined in the network include the proper URIs on the Portal page for the Context URI Text and the Portal URI Text.

    Warning! The URL(s) that are used (either http or https) needs to be consistent to how the user is logged in to invoke the application. For example, if the default local node and Portal node(s) URLs defined on the Portal page for Context URI Text and the Portal URI Text are secure URLs (i.e. https) for ALL nodes in the network, then the user needs to log in via https. Mismatch of secure and non-secure URLs will result in the page selected not properly rendering.

  5. Perform a successful MAP File Synchronization. See Using the MAP File Synchronization Page.

  6. Check that the MAP Session Timeout is set to at least 20 minutes (the default setting is 5 minutes). See Using MAP Security General Page.