6000000000400000 - License capacity is not configured

The license capacity has never been set or the license capacity is set to 0.

By default, up to 120M can be provisioned if license capacity is not set. To use the EPAP Expansion to 480M Database Entries feature, additional capacity (i.e., Required Capacity - Current Purchased Capacity) must be purchased before adjusting the license capacity using the following procedure. For capacity over 255M, 480G drive modules are required.

Recovery

1. Log in to the EPAP CLI as epapdev.
2. Use the manageLicenseInfo utility to check the value of purchased capacity (see the "Current license capacity"):

   $ manageLicenseInfo –l

3. Use the manageLicenseInfo utility to specify the additional amount of desired PDB capacity, where <License Capacity value> is the number of additional licenses required when one license supports 0.5M data (DN, IMSI, and IMEI):

   $ manageLicenseInfo –a <License Capacity value>

   For example, if 120M is currently provisioned and an additional 80M is desired for a new capacity of 200M, 160 should be specified for the <License Capacity value>:

   manageLicenseInfo -a 160

For assistance or additional information, contact My Oracle Support (MOS).