6 FEIG OBID RFID Encoder

Prerequisites Certifications and Compatibility for FEIG RFID OBID

This section describes the minimum requirements for the FEIG RFID OBID encoder Installation module in SPMS.

Prerequisites

  • Obtain the following program executable from FEIG or your local vendor.

    • OBID driver: setup_cprusbio_v2.50 (build 20130214)

    • Card reader driver: ID_CPRStart2014_V090701.msi

  • Download Visual C++ runtime from Microsoft’s website.

    • Vcredist_x86.exe (8.0.50727.6195)

Compatibility

SPMS version 20.1 or later. For customer operating on a version below 20.1 database upgrade to the recommended or latest version is required.

Installing FEIG OBID RFID Encoder

This section describes the steps to set up the FEIG OBID RFID Encoder for use in SPMS.

Visual C++ Runtime Installation

  1. Run the vcredist_x86.exe (version 8.0.50727.6195) to install.

  2. Follow the steps in the setup wizard to complete the installation.

FEIG OBID RFID Driver Installation

  1. Run the setup.exe of the folder setup_cprusbio_v2.50 (build 20130214) to install.

  2. Follow the steps in the setup wizard to complete the installation.

  3. Apply the card reader driver patch by running the ID_CPRStart2014_V090701.msi.

Upoading the DLL files to SPMS database

  1. From OHC Launch Panel, press F12 to start the upload to Special Applications.

  2. Upload:

    1. fecom.dll

    2. FedmIscCoreVC80.dll

    3. FedmIscMyAxxessVC80.dll

    4. fefu.dll

    5. feiscl.dll

    6. fetcl.dll

    7. fetcp.dll

    8. feusb.dll

    9. OBIDISC4NET.dll

    10. OBIDISC4NETnative.dll