Configuring Pool Spanning

This section explains the procedure to configure Pool Spanning feature.

To configure Pool Spanning functionality:

1. Install and configure User Data Repository product on multiple machines. For example, UDR1 and UDR2.
2. Configure ComAgent on OCUDR1 and OCUDR2 as described in the Configuring ComAgent for UDR Machines.
3. Configure Pool Network Table on UDR1 and UDR2. See, Configuring Pool Network.
4. Add entries in the UDR Key Range table on UDR1 and UDR2 for the pool id ranges. See, Inserting UDR Key Range.
5. Optional) Execute the following command on Active NO as a root user only for systems upgraded from User Data Repository product release 12.1 to User Data Repository product release 12.2.
   This step is not required for a system upgraded from User Data Repository product release10.2 or a new installation of User Data Repository product release 12.2.
   iset -fflags=0 Subscription where "flags!=0"
   The command may take up to three hours to complete for a 30M Database. Proceed to step 6 only after completion of Step 5.
6. Run the following command to activate Pool Spanning on Active NO as a root user on User Data Repository system product.
   iset -fvalue=TRUE CommonOptions where "var='PSO_Enabled'"
   iset -fvalue=TRUE CommonOptions where "var='PoolProfileMergeEnabled'"

You have successfully configured the Pool Spanning Feature.