Aborting an Audit

An audit or clean process can be aborted from the Database Auditor page.

You can only perform this task when logged into the Active Primary NOAMP. Note that you must have permission to abort an audit. Permission groups are defined on the Main Menu > Administration > Access Control > Groups page.

To abort an audit or clean process:

1. Select UDR > Maintenance > Database Auditor.

   The Database Auditor page appears.

2. In the State Table section of the page, click to select the audit or clean process to be aborted. The selected process must be in a state of In Progress to be aborted.
   At the bottom of the page, the Abort button is now enabled.
3. Click Abort to stop the audit/clean in progress.

A warning message pops up. To continue the abort, click OK. The abort ends the audit/clean process, and the process in the State Table displays with a State of Aborted. Once aborted, this process can be restarted by specifying the related filename in the audit/clean section of the page and clicking the Audit or Clean button.