Editing a quota reset task

Use this procedure to edit a task that is in the state of Scheduled, Aborted, or Completed (Edit is grayed out if the task is Running or Paused). Modifying a task allows you to rerun an existing task, or change the entire configuration and effectively create a new task.

You can only perform this procedure when logged into the Active Primary NOAMP. Note that you must have permission to edit a task. Permission groups are defined on the Main Menu > Administration > Access Control > Groups page.

1. Select UDR > Maintenance > Quota Reset Scheduler Tasks.
   The Quota Reset Scheduler Tasks page appears.
2. Click on the task to be edited.
   The selected task displays in green.
3. Click Edit.
   The Quota Reset Scheduler Tasks [Edit] page appears.
4. Change existing task values, as needed. The only field that cannot be changed for an existing Quota Reset Scheduler Tasks is the Task ID; to change this field, the existing task must be deleted and a new one created. See Quota Reset Scheduler Tasks elements for more information on each field.
5. Perform one of the following:
   • Click OK to save the task and return to the Quota Reset Scheduler Tasks page.
   • Click Cancel to return to the Quota Reset Scheduler Tasks page without saving the changes.
   If OK is clicked and any of the following exist, an error message appears:

   • Any required field is empty; no value was entered or selected
   • The entry in any field is not valid (wrong data type or out of the valid range)

When the task is successfully changed, the updated task values appear on the Quota Reset Scheduler Tasks page. If the Start Time was changed, the task now displays in a State of SCHEDULED.