Adding MCC Ranges

Use this task to configure new MCC Ranges.

MCC Ranges fields are described in MCC Ranges Elements.

1. On the SOAM, select Diameter Common, and then Network Identifiers, and then MCC Ranges.

   The Diameter Common, and then Network Identifiers, and then MCC Ranges page appears.

2. Click Insert.

   The Diameter Common, and then Network Identifiers, and then MCC Ranges [Insert] page appears.

   If the maximum number of MCC Ranges (10) has already been configured in the system, the Diameter Common, and then Network Identifiers, and then MCC Ranges [Insert] page does not open, and an error message appears.

3. Enter a value for the Start MCC field.
4. Enter a value for the End MCC field.
5. Click:
   • OK to save the new MCC Range and return to the Diameter Common, and then Network Identifiers, and then MCC Ranges page.
   • Apply to save the new MCC Range and remain on this page. The data displayed on the page is updated.
   • Cancel to return to the Diameter Common, and then Network Identifiers, and then MCC Ranges page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Any fields contain a value that is out of the allowed range
   • Any required field is empty (not entered)
   • Adding the new MCC Range would cause the maximum number of MCC Ranges (10) to be exceeded
   • The Start MCC field value is greater than the End MCC field value
   • The MCC Range created lies within the ranges of other MCC Ranges