Editing MCC Ranges

Use this task to change MCC Ranges.

MCC Ranges fields are described in MCC Ranges Elements.

When the Diameter Common, and then Network Identifiers, and then MCC Ranges [Edit] page opens, the fields are populated with the current configured values.

1. On the SOAM, select Diameter Common, and then Network Identifiers, and then MCC Ranges.

   The Diameter Common, and then Network Identifiers, and then MCC Ranges page appears.

2. Select the MCC Range to be changed.
3. Click Edit.

   The Diameter Common, and then Network Identifiers, and then MCC Ranges [Edit] page appears.

4. Change the Start MCC value, the End MCC value, or both.
5. Click:
   • OK to save the changes and return to the Diameter Common, and then Network Identifiers, and then MCC Ranges page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the Diameter Common, and then Network Identifiers, and then MCC Ranges page without saving any changes.

   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • The selected MCC Range no longer exists; it has been deleted by another user
   • Any field contains values that are out of range
   • Any required field is empty (not entered)
   • The Start MCC field value is greater than the End MCC field value
   • The MCC Range created lies within the ranges of other MCC Ranges