1. Diameter Common User Guide
  2. Diameter Common on the NOAM
  3. MCCMNC Configuration
  4. Adding MCCMNC Entries

Adding MCCMNC Entries

Use this task to configure new MCCMNC entries.

MCCMNC fields are described in MCCMNC Elements.
  1. On the NOAM, select Diameter Common, and then Network Identifiers, and then MCCMNC.

    The Diameter Common, and then Network Identifiers, and then MCCMNC page appears.

  2. Click Insert.

    The Diameter Common, and then Network Identifiers, and then MCCMNC [Insert] page appears.

    If the maximum number of MCCMNC entries (2500) has already been configured in the system, the Diameter Common, and then Network Identifiers, and then MCCMNC [Insert] page does not open, and an error message appears.

  3. Enter a value for each field.
  4. Click:
    • OK to save the new entry and return to the Diameter Common, and then Network Identifiers, and then MCCMNC page.
    • Apply to save the new entry and remain on this page. The data displayed on the page is updated.
    • Cancel to return to the Diameter Common, and then Network Identifiers, and then MCCMNC page without saving any changes.
    If OK or Apply is clicked and any of the following conditions exist, an error message appears:
    • Any fields contain a value that is out of the allowed range
    • Any required field is empty (not entered)
    • Adding the new MCCMNC entry would cause the allowed maximum number of entries (2500) to be exceeded
    • The combination of the MCC and MNC field values is not unique (already exists)