Adding MCCMNC Mapping Entries

Use this task to configure new MCCMNC Mapping entries.

MCCMNC Mapping fields are described in MCCMNC Mapping Elements.

1. On the NOAM, select Diameter Common, and then Network Identifiers, and then MCCMNC Mapping.

   The Diameter Common, and then Network Identifiers, and then MCCMNC Mapping page appears.

2. Click Insert.

   The Diameter Common, and then Network Identifiers, and then MCCMNC Mapping [Insert] page appears.

   If the maximum number of MCCMNC entries (2500) has already been configured in the system, the Diameter Common, and then Network Identifiers, and then MCCMNC Mapping [Insert] page does not open, and an error message appears.

3. Enter a value for each field.
4. Click:
   • OK to save the new entry and return to the Diameter Common, and then Network Identifiers, and then MCCMNC Mapping page.
   • Apply to save the new entry and remain on this page. The data displayed on the page is updated.
   • Cancel to return to the Diameter Common, and then Network Identifiers, and then MCCMNC Mapping page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, an error message appears:

   • Any fields contain a value that is out of the allowed range
   • Any required field is empty (not entered)
   • Adding the new MCCMNC Mapping entry would cause the allowed maximum number of entries (2500) to be exceeded
   • The MCC+MNC+MSIN Prefix Digits entry is not unique (already exists)