8 Auto Update Pre-Register RFID Card on Online Door Lock System

This function is only applicable to ships running OHC VisiOnline in Onlne mode, which allows the registration of board cards at QCIShore DB using the web services RegisterRFIDBoardCard function.

This function pushes the pre-registered RFID ID to the VisiOnline System automatically, requesting access to the door lock, or a call for an update of the RFID ID of the lock.

The following scenarios explains the process during the registration of the card.

Guest A Card is registered and the RES_QCI_RFID_ID is updated with the RFID UID.

The record is updated to the Ship DB in RES_QCI_RFID_ID field and inserted into the RFID table with RFID_ACTIVE = 1 and RFID_AUTO_UPD = 1, and then runs WPF Security in Ship DB.

Scenario 1

  1. Scan the card registered card for Guest A using OMNIKey 5321.

    A record is created and added to PVF and send to VisiOnline with PVF_CMD=ResPostCheckIn.

  2. CCE command is send to Ving to check in the card.

Scenario 2

The RES_QCI_RFID_ID is updated, but the record is not created in the RFID table in Ship DB.

  1. Scan the card to check in at Gangway.

  2. The record is added to RFID and the PVF table

Scenario 3

The RES_QCI_RFID_ID is updated, but the record is not created in the RFID table in Ship DB, and the Guest status is Onboard.

  1. Scan the card at the Gangway and this guest is placed in shore side. The RFID record is inserted.

  2. Scan the card again, and the guest shows as going onboard and checked in.

  3. Once the record is checked in, the record is added to the PVF table, to be send to VisiOnline

  4. The system inserts to PVF when the RES_STATUS changes from RE to CC.

Scenario 4

If the RES_BOARDCC for the guest does not match the registered card track 2 value,

  1. Scan the card at the Gangway.

  2. System shows the card as not recognized.