1. Measurement Reference Guide
  2. Measurements
  3. OC-DRA Diameter Exception measurements
  4. RxGyRoReqFailedToRelayPerCmd

3.55.2 RxGyRoReqFailedToRelayPerCmd

Measurement ID
11395
Measurement Group
OC-DRA Diameter Exception
Measurement Type
Simple
Measurement Dimension
Arrayed (by Diameter Request Command Abbreviation, i.e., CCR-I/U/T/E, RAR, UNK-REQ and “Total”)
Description
The number of Gy/Ro Diameter Credit Control Application Request messages OC-DRA failed to relay.
Collection Interval
5 min
Peg Condition
Each time the Policy and Charging DSR Application (PCA) initiates an Answer response with a non-successful Result-Code (one containing a non-2xxx value) or discards an ingress Request message for any of the following reasons:
  • OC-DRA functionality is Unavailable or Disabled
  • Diameter Protocol Error Detected
  • OC-DRA specific errors due to absence of mandatory Diameter Credit Control Application AVP(s) used for routing
  • Diameter Request discarded during Congestion
  • Diameter Message Routing failure due to DRL's Request Queue Full
  • Communication Agent Error (i.e., Queue Full)
  • Unexpected SBR Error
  • Online Charging Session not found when required for routing
  • Diameter Routing Layer failed to relay the Diameter Request (e.g., an unavailable peer or invalid route specification)

Note:

This measurement is only pegged once for an ingress Request message.
Measurement Scope
Server Group

Recovery

  1. This measurement gives an indication if any Gy/Ro Diameter Credit Control Application Request messages were NOT successfully relayed by OC-DRA. OC-DRA can fail to relay Gy/Ro Diameter Credit Control Application Request messages for various reasons as stated above for “Peg Condition”.
  2. This measurement is the summation of the following measurements which should be inspected within the same collection interval to further determine the specific cause of failure:

    Note:

    Due to the timing of when measurements are incremented and collected during a collection interval, this measurement may not be the exact sum of the measurements listed above.