9.7.2 Adding an S9 AF/pCSCF Topology Hiding Configuration Set

Use this task to create a new S9 AF/pCSCF Topology Hiding Configuration Set.

For more information about the fields, see Diameter S9 AF/pCSCF Topology Hiding Configuration Set Elements.

1. Click Diameter, and then Configuration, and then Topology Hiding, and then S9 AF/pCSCF Topology Hiding Configuration Sets.

   Note:

   If the maximum number of Configuration Sets allowed in the system (500) has been configured, then the S9 AF/PCRF Topology Hiding Configuration Sets page does not open.
2. Click Insert.
3. Enter a unique name for the Configuration Set in the S9 AF/pCSCF Topology Hiding Configuration Set Name field.
4. Enter a unique name to be used when replacing the S9 AF/pCSCF Hostname in the S9 AF/pCSCF Pseudo Hostname field.
5. Click:
   • OK to save the changes and return to the S9 AF/pCSCF Topology Hiding Configuration Sets page.
   • Apply to save the changes and remain on this page.
   • Cancel to return to the S9 AF/pCSCF Topology Hiding Configuration Sets page without saving any changes.
   If OK or Apply is clicked and any of the following conditions exist, then an error message appears:

   • Any required field is empty (no value was entered).
   • The value in any field is not valid or is out of range.
   • The S9 AF/pCSCF Topology Hiding Configuration Set Name is not unique; it already exists in the system.