1. Full Address Based Resolution User Guide
  2. Configuration of FABR
  3. Pre-Configuration Activities
  4. UDR Remote Server Configuration

3.1.5 UDR Remote Server Configuration

Use this procedure to configure UDR Remote Servers to allow FABR to use UDR for address lookup and resolution.

  1. From the active NOAM, click Communication Agent, and then Configuration, and then Remote Servers.
  2. Click Insert.
  3. Enter a unique Remote Server Name.
  4. Enter the Remote Server IP Address.
    Specify the IP address that can be reached via a server’s Internal Management Interface (IMI). The IP address uniquely identifies the Remote Server and provides the means by which Communication Agent can establish transport connections to/from the Remote Server.
  5. For Remote Server Mode, select Server.
  6. Assign the Remote Server to one of the Available Local Server Groups.
  7. Click Ok.
  8. Select Communication Agent, click Configuration and then select Connection Groups.
  9. Select the UDRSvcGrp and click Edit.
  10. Assign the Remote Server you just created to the UDRSvcGrp Connection group.
  11. Click Ok.
  12. Expand the Servers assigned to the UDRSvcGrp to see that the new Remote Server is now included.
  13. Restart the Message Processor.
The operational status of what was provisioned can be verified by using the Communication Agent, and then Maintenance pages.
  • Click Communication Agent, and then Maintenance, and then Connection Status to verify all Remote Server connections added are shown as InService on all local servers.
  • Click Communication Agent, and then Maintenance, and then Routed Service Status to verify the status is Available for all local servers that are provisioned to connect.