Configuring Vertex O Series Integration

This section discusses how to activate the TAX_INTEGRATION service operation queue, activate the service operations, activate the routings, and activate the PSFT_TAX node.

Pages Used to Configure Vertex O Series Integration

Page Name	Definition Name	Usage
Queue Definitions Page	IB_QUEUEDEFN	Activate the TAX_INTEGRATION service operation queue.
Service Operation - General Page	IB_SERVICE	Activate the service operations.
Service Operation - General Page	IB_SERVICETRNGS	Activate the routings.
Node Definitions Page	IB_NODE	Activate tax node.

Queue Definitions Page

Use the Queue Definitions page (IB_QUEUEDEFN) to activate the TAX_INTEGRATION service operation queue.

Navigation:

PeopleTools, Integration Broker, Integration Setup, Queues

For the TAX_INTEGRATION queue, verify that the Queue Status is Run.

Service Operation - General Page

Use the Service Operation - General page (IB_SERVICE) to activate the service operations.

Navigation:

PeopleTools, and then Integration Broker, and then Integration Setup, and then Service Operations

PeopleSoft delivers service operations in PeopleSoft Integration Broker with a default status of Inactive. You must activate each service operation before attempting to send or receive data from a third-party source, such as Vertex. To setup a service operation use the information in the table below and refer to the setup instruction in Setting Up Service Operations

Service Operation	Direction and Type	Handlers	Chunking Available?	Integrates With
DO_TAXCALC_REQ	Outbound Synchronous	Not applicable	No	Vertex O Series or another third-party tax supplier
GET_GEOCODES_REQ	Outbound Synchronous	Not applicable	No	Vertex O Series

Service Operation

Direction and Type

Handlers

Chunking Available?

Integrates With

DO_TAXCALC_REQ

Outbound

Synchronous

Not applicable

Vertex O Series or another third-party tax supplier

GET_GEOCODES_REQ

Outbound

Synchronous

Not applicable

Vertex O Series

See PeopleTools: Integration Broker Service Operations Monitor

Service Operation - General Page

Use the Service Operation - General page (IB_SERVICETRNGS) to activate the routings.

Navigation:

PeopleTools, and then Integration Broker, and then Integration Setup, and then Service Operations

Click the Routings tab.

Activate the DO_TAXCALC_REQ_V2 and the GET_GEOCODE_REQ_TAX routings for the PSFT_TAX node.

For the DO_TAXCALC_REQ_V2 routing, set the PrimaryURL property to the endpoint of the Vertex tax calculation request function.

Typically this will be: http://<host:port>/pgc/servlet/taxcalc. Replace <HOST:PORT> with the address of the Vertex PeopleSoft generic connector.
For the GET_GEOCODE_REQ_TAX routing, set the PrimaryURL property to the endpoint of the Vertex tax area request function.

Typically this will be: http://<host:port>/pgc/servlet/taxarealookup. Replace <HOST:PORT> with the address of the Vertex PeopleSoft generic connector.

See Manage Routing Definitions, PeopleTools: Integration Broker

Node Definitions Page

Use the Node Definitions page (IB_NODE) to activate tax node.

Navigation:

PeopleTools, Integration Broker, Integration Setup, Nodes

Verify that the PSFT_TAX node is active.

See Adding and Configuring Nodes, PeopleTools: Integration Broker