Understanding Minimum Configuration Requirements for the Integration Network

The Configuration Status page indicates if the integration network is minimally configured to run. The following table lists the minimum configuration requirements for the network.

Note:

All nodes to be managed and monitored in the Integration Network must be PeopleSoft nodes. PeopleSoft nodes are those nodes defined as PIA node types in the node definition.

Required Configuration	Page and Object ID	Integration WorkCenter Navigation	Alternate Integration Broker Navigation
Define a local gateway. This gateway represents the source system. In the definition you must specify a gateway URL and specify that the gateway is local. Load the target connectors. Define one or more remote gateways. These gateways represent the target systems. In each remote gateway definition you must specify the URL of the remote gateway. Load the target connector for each gateway.	Gateways – Gateways page IB_GATEWAY	Gateway Configured Update Gateway Location Register Target Connectors	PeopleTools, and then Integration Broker, and then Configuration, and then Integration Gateways.
Register and configure PeopleSoft nodes on the local gateway. You must first create local and remote node definitions before you can register and configured them on the local gateway.	Gateways – PeopleSoft Node Configuration page (PSGTWPROPS_SEC)	Gateway Configured, Update Configuration Settings	PeopleTools, and then Integration Broker, and then Configuration, and then Integration Gateways., and then Gateway Setup Properties.
In the Integration Gateway CERTIFICATE Section of the integration gateway properties file for each gateway defined, specify the secure keystore path and password.	Gateway Properties page (BGWPROPERTIESPAGE)	Node Network Configured	PeopleTools, and then Integration Broker, and then Configuration, and then Integration Gateways., and then Gateway Setup Properties, and then Advanced Properties Page.
Default Local Node: Rename or define the local default node. This node represents the source system. Activate the default local node. Remote Nodes: Define remote nodes as warranted. The remote nodes represent target systems. Activate the nodes. Assign the nodes to a gateway. After you create local and remote node definitions, you must register and configure them on the gateway using the PeopleSoft Node Configuration page.	Nodes – Node Definitions (IB_NODE)	Node Network Configured	PeopleTools, and then Integration Broker, and then Integration Setup, and then Node Definitions, and then Node Definitions.
Assign the default local node and any other local nodes to a gateway and target connector.	Nodes-Connectors page (IB_NODECONN)	Node Network Configured	PeopleTools, and then Integration Broker, and then Integration Setup, and then Node Definitions, and then Connectors.
Activate the application server domain.	Domain Status (AMM_MULTIDOM)	Domain Active	PeopleTools, and then Integration Broker, and then Service Operations Monitor, and then Administration, and then Domain Status.
Set the network node password.	Update Network Node Password (IB_INTNET_NODEPWD)	Node Network Password (This link is located in the Additional Links section at the bottom of the page.)	PeopleTools, and then Integration Broker, and then Integration Network, and then Configuration Status . In the Additional Links section, click Node Network Password.