Configuring the Replacement Compute Server
The replacement compute server does not have a host names, IP addresses, DNS, or NTP settings. This task describes how to configure the replacement compute server.
The information must be the same on all compute servers in Recovery Appliance. You can obtain the IP addresses from the DNS. You should also have a copy of the Installation Template from the initial installation.
To configure the replacement compute server:
Note:
-
If the compute server does not use all network interfaces, then the configuration process stops with a warning that some network interfaces are disconnected. It prompts whether to retry the discovery process. Respond with
yes
orno
, as appropriate for the environment. -
If bonding is used for the ingest network, then it is now set in the default active-passive mode.